OscilloscopeContact us
SINOSOURCE LAB SUPPLIERS
Company Name：Sinosource Lab Supplies Ltd.
Contact Person：Mr.YeWei Chen
Skype: sinosourcelab
WeChat and WhatsApp: +86 138 2500 3364
E-Mail: info@sinosourcelab.com
Tel: 86-20-83235069,83292911
Fax: 86-20-83292962
Mobile: 86-13825003364
Postcode: 510375
Address: Room 805-808, No.1, Weigu 2nd Street, Liwan District, Guangzhou, China
Physics Lab Equipment
- 2 channel digital oscilloscopes 1020s 1050s 1100s
Unless otherwise specified, the technical specifications applied are for the oscilloscope only, and Probes attenuation set as 10X. Only if the oscilloscope fulfills the following two conditions at first, these specification standards can be reached.
n This instrument should run for at least 30 minutes continuously under the specified operating temperature.
n If change of the operating temperature is up to or exceeds 5℃, do a "Self-calibration" procedure (see "How to Implement Self-calibration" on P12).
All specification standards can be fulfilled, except one(s) marked with the word "Typical".
|
Performance Characteristics
|
Instruction
|
|||
|
Bandwidth
|
1020S
|
20 MHz
|
||
|
1050S
|
50 MHz
|
|||
|
1100S
|
100 MHz
|
|||
|
Channel
|
2 channels
|
|||
|
Acquisition
|
Mode
|
Normal, Peak detect, Averaging
|
||
|
Sample rate
(real time)
|
1020S
|
100 MS/s
|
||
|
1050S
|
500 MS/s
|
|||
|
1100S
|
1 GS/s
|
|||
|
Input
|
Input coupling
|
DC, AC , Ground
|
||
|
Input impedance
|
1 MΩ±2%, in parallel with 20 pF±5 pF
|
|||
|
Input coupling
|
1X，10X，100X，1000X
|
|||
|
Max. input voltage
|
400V (DC+AC, PK - PK)
|
|||
|
Channel –channel isolation
|
50Hz: 100 : 1
10MHz: 40 : 1
|
|||
|
Time delay between channel(typical)
|
150ps
|
|||
|
Bandwidth limit
|
1020S
1050S
|
Not support
|
||
|
1100S
|
20 MHz, full bandwidth
|
|||
|
Horizontal System
|
Sampling rate range
|
1020S
|
0.5 S/s～100 MS/s
|
|
|
1050S
|
0.5 S/s～500 MS/s
|
|||
|
1100S
|
0.5 S/s～1 GS/s
|
|||
|
Interpolation
|
(Sinx)/x
|
|||
|
Max Record length
|
10K
|
|||
|
Scanning speed (S/div)
|
1020S
|
5 ns/div – 1000 s/div,
step by 1 – 2 - 5
|
||
|
1050S
1100S
|
2 ns/div – 1000 s/div,
step by 1 – 2 - 5
|
|||
|
Sampling rate / relay time accuracy
|
±100 ppm
|
|||
|
Interval(△T) accuracy
(DC - 100MHz)
|
Single：
±(1 interval time+100 ppm×reading+0.6 ns);
Average>16：
±(1 interval time +100 ppm×reading+0.4 ns)
|
|||
|
Vertical system
|
Vertical Resolution (A/D)
|
8 bits (2 channels simultaneously)
|
||
|
Sensitivity
|
5 mV/div～5 V/div
|
|||
|
Displacement
|
±2 V (5 mV/div – 100 mV/div)
±50 V (200 mV/div – 5 V/div) |
|||
|
Analog bandwidth
|
1020S
|
20 MHz
|
||
|
1050S
|
50 MHz
|
|||
|
1100S
|
100 MHz
|
|||
|
Single bandwidth
|
Full bandwidth
|
|||
|
Low Frequency
|
≥10 Hz (at input, AC coupling, -3 dB)
|
|||
|
Rise time (at input, Typical)
|
1020S
|
≤ 17.5 ns
|
||
|
1050S
|
≤ 7.0 ns
|
|||
|
1100S
|
≤ 3.5 ns
|
|||
|
DC gain accuracy
|
±3%
|
|||
|
DC accuracy (average)
|
Delta Volts between any two averages of ≥16 waveforms acquired with the same scope setup and ambient conditions (△V):
±(3% reading + 0.05 div) |
|||
|
Waveform inverted ON/OFF
|
||||
|
Measurement
|
Cursor
|
△V, △T, △T&△V between cursors,
auto cursor |
||
|
Automatic
|
Period, Frequency, Mean, PK-PK, RMS, Max, Min, Top, Base, Amplitude, Overshoot, Preshoot, Rise Time, Fall Time, +Pulse Width, -Pulse Width, +Duty Cycle, -Duty Cycle, Delay A→B, Delay A→B, Cycle RMS, Cursor RMS, Screen Duty, Phase, +Pulse Count, -Pulse Count, Rise Edge Count, Fall Edge Count, Area, and Cycle Area.
|
|||
|
Waveform Math
|
＋, －, *, / ,FFT
|
|||
|
Waveform storage
|
16 waveforms
|
|||
|
Lissajous figure
|
Bandwidth
|
Full bandwidth
|
||
|
Phase difference
|
±3 degrees
|
|||
|
USB 2.0 (USB storage）
|
||||
|
Counter
|
Support
|
|||
Trigger:
|
Performance Characteristics
|
Instruction
|
|
||
|
Trigger level range
|
Internal
|
±5 div from the screen center
|
||
|
Trigger level Accuracy (typical)
|
Internal
|
±0.3 div
|
||
|
Trigger displacement
|
According to Record length and time base
|
|||
|
Trigger Holdoff range
|
100 ns – 10 s
|
|||
|
50% level setting
(typical) |
Input signal frequency ≥ 50 Hz
|
|||
|
Edge trigger
|
slope
|
Rising, Falling
|
||
|
Video Trigger
|
Modulation
|
Support standard NTSC, PAL and SECAM broadcast systems
|
||
|
Line number range
|
1-525 (NTSC) and 1-625 (PAL/SECAM)
|
|||
Display
|
Display Type
|
7" Colored LCD (Liquid Crystal Display)
|
|
Display Resolution
|
800 (Horizontal) × 480 (Vertical) Pixels
|
|
Display Colors
|
65536 colors, TFT screen
|
Output of the Probe Compensator
|
Output Voltage (Typical)
|
About 5 V, with the Peak-to-Peak voltage ≥1 MΩ.
|
|
Frequency (Typical)
|
Square wave of 1 KHz
|
Power
|
Mains Voltage
|
100 - 240 VACRMS, 50/60 Hz, CAT Ⅱ
|
|
Power Consumption
|
< 15 W
|
|
Fuse
|
2 A, T class, 250 V
|
Environment
|
Temperature
|
Working temperature: 0 ℃ - 40 ℃
Storage temperature: -20 ℃ - 60 ℃
|
|
Relative Humidity
|
≤ 90%
|
|
Height
|
Operating: 3,000 m
Non-operating: 15,000 m
|
|
Cooling Method
|
Natural cooling
|
Mechanical Specifications
|
Dimension
|
301 mm× 152 mm×70 mm (L*H*W)
|
|
Weight
|
About 1.1 kg
|
Up Page：Power supply
Next Page：No
Laboratory">
Medical">
Teaching">
Agriculture">